CiscoWorks adding PIX

[cuba2112]

I have a few sites that have the pix firewall in a DMZ and I need to know if it is possible to use CiscoWorks to monitor and back up all of the devices including the pix's in DMZ.

Would it be as simple as adding the SNMP and loopback address?

[David Stanford · Accepted solution]

You can add the PIX via an snmp accessible address and then use the read-only community string in the device credentials when adding the device into

RME 3.5 or the DCR (LMS 2.5)

You also need to make a device configuration to allow snmp access:

a. snmp-server host where x.x.x.x is the IP Address of CW2K server and interface is where the CW2K server packets will come through

b. snmp-server community

[cuba2112]

Excellent Daivd your recommendation worked out great.