Configuration after changing to multiple mode

[aoun.ameur1]

Hi All,

I need to know if the configuration of intrefaces (IP Address) in single mode will be erased after changing from this mode to multiple mode.

Thanks in advance

[Akshay Rastogi]

Hi there,

When you change from single mode to multiple mode, then your original single mode configuration gets saved in flash with the name 'old_running.cfg'.

Go through the link below. It explains it in detail:

http://www.cisco.com/c/en/us/td/docs/security/asa/asa81/config/guide/config/contexts.html#wp1051132

Restoring back to single mode:

http://www.cisco.com/c/en/us/td/docs/security/asa/asa81/config/guide/config/contexts.html#wp1036450

Hope it helps.

Regards,

Akshay Rastogi

Remember to mark the answer as correct if it answers your query or rate the helpful posts.

[aoun.ameur1]

thank you Akshay

But, I mean that if I am configuring the asa in remote and i change the context mode from single to multiple. After Rebooting, Can I access the ASA with same IP@ as configuring in single mode ?

Thanks in advance

[Akshay Rastogi · Accepted solution]

Hi.

I am afraid, not. When you change mode, ASA boots up with blank configuration. Perform with console access to keep access of ASA.

Regards,

Akshay Rastogi

Remember to mark the answer as correct if it answers your query or rate the helpful posts.

[aoun.ameur1]

Thanks a lot