- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-06-2017 01:01 AM - edited 03-12-2019 02:19 AM
Hello Cisco Support community. I have purchase a used cisco asa 5505 device. I connect the device any how. But my main obligation is related configuration. I can access device through putty. But I have old frame ware that is cisco system Rommon 1.0(12) 13. How to install a new vesion asdm and asdm installer for this device. Hardware version may be ASA 5505 V5. May I get a free asdm or Shall I purchase? If get this, How to install it.
Solved! Go to Solution.
- Labels:
-
NGFW Firewalls
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-06-2017 09:21 PM
Unless it has been deleted there should be both ASA software and an ASDM image on your disk0:/ (internal compact flash).
Unfortunately simply owning a used ASA does not entitle you to updates or downloads of either image type. For that you need a service contract with Cisco.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-06-2017 09:21 PM
Unless it has been deleted there should be both ASA software and an ASDM image on your disk0:/ (internal compact flash).
Unfortunately simply owning a used ASA does not entitle you to updates or downloads of either image type. For that you need a service contract with Cisco.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-07-2017 08:22 PM
Thank very much Sir for your kind guidance. I shall contact to cisco service contract manager.
