Configuration restore Error
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-18-2011 07:49 AM - edited 03-10-2019 05:31 AM
Hi,
I am trying to restore a IPS configuration after a re-image with the same version.
Model: AIP-SSM-10
I get the following error:
Error: Invalid configuration: 'Error: /enabled/password/ -- the value is empty and has no default
Example:
sensor# copy ftp://user@xxx.xxx.xxx.xxx/config.txt current-config
Password: ***********
Warning: Copying over the current configuration may leave the box in an unstable state.
Would you like to copy current-config to backup-config before proceeding? [yes]: no
Warning: Replacing existing network-settings may leave the box in an unstable state.
Would you like to replace existing network settings(host-name/ipaddress/netmask/gateway/access-list) on the sensor? [no]: yes
Error: Invalid configuration: 'Error: /enabled/password/ -- the value is empty and has no default
Anybody has an idea of the cause of the problem ?
Thank-You!
Pascal
- Labels:
-
IPS and IDS

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-30-2011 12:23 AM
I suppose that your config stored on ftp-server was repaired by hands and it contains one more "exit" string in signatures configuration section. Then, after this "exit" string you try to enable signature but sensor thinks that this string ("enabled") must be typed in global config mode.
