cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

986
Views
0
Helpful
1
Replies
Highlighted
Beginner

Configuring NAT, port forwarding, failover on ASA 5550

Hello Everyone,

I've two Cisco ASA 5550 firewall. I'm don't have much knowlege on configuring this kind of firewall. I need help on configuring these firewall for simple NAT. I have 3 public IP address. I would like to allow server's inside of the firewall to be able to connect to internet using private address. A basic NAT. Also need to configure some port forwarding. We've bought two firewall for the Active/Active failover support. How can i configure this through ASDM? My ASDM version is 5.2.

I would be greatful if you please help me on this. Thanks in advance.

Regards,

Saif

1 REPLY 1
Highlighted
Beginner

I've connected through ASDM and configured like this:

First Firewall:

Interface GigabitEthernet 0/0 as LAN, IP: 10.190.0.10      Subnet mask: 255.255.248.0

Interface GigabitEthernet 1/0 as WAN, IP: 203.76.114.97         Subnet Mask: 255.255.255.224

Interface Management 0/0 as management, 10.190.10.1          Subnet Mask: 255.255.255.248

Second Firewall:

Interface GigabitEthernet 0/0 as LAN, IP: 10.190.0.11      Subnet mask: 255.255.248.0

Interface GigabitEthernet 1/0 as WAN, IP: 203.76.114.98         Subnet Mask: 255.255.255.224

Interface Management 0/0 as management, 10.190.10.2          Subnet Mask: 255.255.255.248

Content for Community-Ad