Configuring NAT with IPv6 on ASA..???

[arikawahyono]

Hello Anyone,

I want to configuring my server that can be access from Outside with IPv6..

Anyone have experience configuring NAT with IPv6 on ASA before???

Please share to me, because i dont find any document about NAT with IPV6 on cisco.com and other forum..

Thanks,,

Best Regards,

[mirober2 · Accepted solution]

Hi Arika,

One of the goals of IPv6 was to increase the size of the available addressing space to the point where NAT would be unecessary. Therefore, the ASA does not have any kind of NAT functionality for IPv6 addresses.

Just for your reference, here is the list of IPv6-enabled commands on the ASA:

http://www.cisco.com/en/US/docs/security/asa/asa82/configuration/guide/route_overview.html#wpmkr1098513

Hope that helps.

-Mike

[arikawahyono]

Thanks for your information mirober2...

your answer very helpful...

GBU..

Best Regards,

---- CASE CLOSED ----

[Mark Walters]

Hi All -

Please note that as of 9.0 code the ASA does support IPv6 NAT in various flavors - Nat66, Nat64, Nat46.

http://www.cisco.com/c/en/us/td/docs/security/asa/asa90/configuration/guide/asa_90_cli_config/nat_overview.html#pgfId-1220768

cheers

mark