Connection to Pix Issues

[cliffordpa]

Hi,

I have two Pix firewalls in HA mode (Active/Standby). I can connect to the active firewall (F1) but not to the standby firewall (F2). I can ping the firewall F2 and the shaow fail advised that it is there and in standby mode. If i swop the firewalls so that the active becomes the standby using the failover command then i can connect to the new active firewall f2 but i cannot connect to the new standby firewall F1.

Has anyone seen this before?

I am using Version 7

Thanks in advance.

[thomas.chen]

Refer to the document PIX/ASA 7.x Active/Standby Failover Configuration Example

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00807dac5f.shtml