01-22-2002 07:47 PM - edited 02-20-2020 09:57 PM
Hi,
I find it is very difficult to upgrade code from down level code to high level code when I need download config .
In pix code upgrade precedure , I know pix can upload config to PC using tftp. But in that , it have no download config from pc to pix.
Thanks
My e-mail : jhlin@tw.ibm.com
01-23-2002 06:26 AM
you can use conf net x.x.x.x:filename, where x.x.x.x is the IP of your tftp server and filename is the name of the pix config file in your tftp server's default tftp directory.
Hope that helps
Mike
01-23-2002 06:29 AM
Which version of the Pix software are you running? If it is 5.0 or greater all you have to do is use the copy command to copy from tftp to flash. If it is pre-ver 5.0 then you will need to boot it in monitor mode and then it is a few more steps. Let me know and I'll forward the pre-ver 5 if needed.
Scott
01-23-2002 07:05 AM
Hi,
Thanks to your reply. My pix use 6.1.1 and I find
config net xx.xx.xx.xx is ok.
Regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide