CW2000 with tacacs+

[CSCO10456946]

I need to set up access on VPN/Security Management Solution with Taccas+.

After I install this component of CW2000 i syncronyze him (and register application) with tacacs(vpn/SecurityManagementSolution/Administration/Configuration/AAA-Server-syncronyze and register application). After I do this in configuration of grops I have new entries (PixMC,ManagementCenter for Firewalls,Autoupdate,AutoUpdateServer,IOSMDC,Management Center for VPNRouters) but this entries don't appear under User Configuration to assign different wrights to users.

I make something wrong or is a possibility to have this entries under User Configuration?

[drolemc]

You need to check if the two are interoperable. For example, interop information for CSACS 3.3 and CW VMS can be found at http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_device_support_table09186a00802527aa.html#wp27361.