DEFENSE CENTER-event logs doesn't show properly

[WEERAKOO69BA]

Dear All, I have an issue with event logs. model defense center 4000 version 5.4.1(59) When I brows    analysiis--connection --events---not showing more than a day In the same way If I tried to see the events with in 2 hours,doesn't show anything I can set the time frame which I need to see the events even for an year.But it shows maximum one year.I have checked settings too.But all seems to be ok.Restarted the maching too.Can Anyboy suggest a solution?  Highly appreciate.

Thank You

[Marvin Rhoads]

Check that you don't have event pruning setup to delete the old records. (System > Local > System Policy > Database)

Besides that, I don't know a specific BugID that would cause that to happen, but you are running a very old version of Defense Center. I'd recommend you upgrade to at least Version 6.1.

[WEERAKOO69BA]

Thanks Marvin.

I will do that and update.

[WEERAKOO69BA]

Dear Marvin,

I tried to go   System > Local > System Policy > Database.But  Database couldn't find.Instead found the "data purge" and attached the screen shot.is this the one you r referenring?

[Marvin Rhoads]

More or less - your older 5.4 system does not have the more advanced settings that I cited from a 6.x FMC.

Given what you have, the issue I was thinking should not apply to you.

Do you have the ability to Open a TAC case? If so, they can probably best assist you in digging deeper.