Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,I need to upgrade ASA 5525-9.4 to 9.8FMC(virtual ) existing version is 5.4.1SFR existing version is 5.4.0 My first question is ,do I have to check the compatibility with ASA version for SRF? Or since ,SRF totally managed by FMC,I have to ...
Dear All,
I have created the repository in the local disk and uploaded the IOS to the repository. And tried to do the upgrade as follows.This is two node deployment.
Upgrading from 2.1.0.474 to 2.4.0.357
ISE02/admin# application upgrade prepar...
Dear Friends,
After scanning from a third software,I am getting a message "Network Time Protocol Daemon (ntpd) monlist Command Enabled DoS"
I have removed ntp configuration on switches(6500) as a workaround. Still I am getting the same warning once s...
Dear all,
I am planning to upgrade FMC(5.4.1) to 6.2.
Can anybody tell me the upgrade path?
And also in my environment SFR and NGIPS also running with 5.3.Should I have to upgrade those too?
Pls advice
Thank you
Dear All, I have an issue with event logs. model defense center 4000 version 5.4.1(59) When I brows analysiis--connection --events---not showing more than a day In the same way If I tried to see the events with in 2 hours,doesn't show anything I c...
Thank you for the reply.In the document you have shared ,says, need to check the ASA and SFR compatibility.*SFR vs ASA no need ,since SFR managed by FMC --Yes <--No need to check ,correct? I could not find any document given SFR compatibility with ...
Thanks a lot for you all prompt reply.Could you pls clarify,do I have to check the compatibility mx of SFR and ASA?This is my confusion. *ASA vs FMC compatibilty need to check*SFR vs FMC compatibility need to check*SFR vs ASA no need ,since SFR m...
Dear All,
Thanks every one for sharing your solutions and helping me.
What I did was ,rather than going to 2.4 straightaway to 2.4 ,upgraded successfully the secondary node from 2.1 to 2.2. Now primary is in 2.1 and secondary one in 2.2.
When I try...
Thanks for the reply.
I already copied the file to the local disk.That means repository is local.It should open correct?
File type is correct.
Only thing I found is both nodes are having same time but different than the system time.Since the file...
