cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
120
Views
0
Helpful
0
Replies

Define a privilege command for show ipv6 access-list

Otaso
Level 1
Level 1

Hello,

I managed to set up a privilege level 4 with a list of show commands:

privilege show level 4 mode exec command access-list

which allows the user to execute show access-list

Now I need to add a line for show ipv6 access-list which I currently don't see how to achieve because after the command keyword only one word is allowed; ipv6 access-list are two words and are not accepted...

I can define privilege show level 4 mode exec command ipv6 but this enables all sub command under ipv6 .

Is it possible to explicitely allow only show ipv6 access-list and how can this be done?

Thanks in advance.

 

0 Replies 0
Review Cisco Networking for a $25 gift card