Hello Folks!
Is my first time that I´m configurin DMZ on ASA. I create a interface with security level 50, my outside is 0 and inside 100, All intefaces with diferent IP range.
Based on security level the inside should be able to talk to dmz, but is not working, I include some rules to allow the traffic from one to another, even any any and machine from inside can´t talk to dmz.
When I use packetracer on ASDM to see where is the traffic is stopping, he say that is in the ACL. How is possible if there is a rule to allow any any in all interface?
Other probleme, I create a NAT the same as the inside to dmz range, but when I include the IP in the same range that dmz interface in my machine, change the vlan in the switch, I can´t access the internet.
I saw may sites about DMZ, but the almost all of then is old and talk about 5505, some command is different, I know that DMZ don´t have to access everything from inside, but first I just want make sure that the comunication is working, after that make filter.
