Dynamic DNS Client in FTD
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-29-2020 08:06 AM
Hi Everyone!
I have an FTD 1010 managed by FMC, and I would like to configure a Dyndns client on it, since one of the interfaces of my ISP is DHCP, all the documentation I found so far is the creation of the internal DDNS. Would anyone know how to proceed?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-03-2020 07:51 PM
Hi,
I did some digging about your request and found this doc (link below), not sure if this is what you are looking for:
HTH
Regards,
Chakshu
Do rate helpful posts.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-04-2020 07:47 AM
Hello @Chakshu Piplani!
Thanks for your reply!
I believe that this configuration is for my LAN, I needed to configure it for my ISP, configure a ddns client as a dyndns or noip for example, is there a possibility of this configuration?
