easy vpn or equivalent

[adamgibs7]

Dear Experts

if i am not wrong in Cisco we have a below vpn

IPSEC vpn ( point to point)

DMVPN

EZVPN

AnyConnect VPN for remote users

I have a 13 sites including 12 sites, on 12 small sites they have ADSL connection and in HO they have static ( my guess) so i can propose them easy vpn solution for their ADSL connection whenever their public  IP change they will form the vpn to HO.

will this solution will work.

Thanks 

[Rob Ingram]

Hi,
What hardware are you planning to use ASA or IOS Router?

- DMVPN/FlexVPN Site-to-Site VPN are supported on IOS Routers
- Dynamic/Static Crypto Map and VTI are supported on ASA

I'd personally use an IOS Router with either DMVPN or FlexVPN, this allows dynamic spoke-to-spoke tunnels to be established. As long as the Hub router has a static IP address the spoke routers, can have a dynamic IP address and still establish a VPN tunnel.

You can use any AnyConnect Remote Access VPN on either ASA or IOS Router (FlexVPN).

HTH

[adamgibs7]

Dear RJI

i m preferring to provide ASA firewall which will do the IPS/malware/url functionality also for internet traffic , so on ASA 550X with firepower services, easy vpn can be configured with PPOE configuration but they don't have a small RJ11 interface as such routers have for ADSL connection which connects to telephone line, so in such case i have to approach ISP for the interface connection,

https://www.cisco.com/c/en/us/td/docs/security/asa/asa912/configuration/vpn/asa-912-vpn-config/vpn-easyvpn.html

Also i would like to know the DMVPN is supported in ASA/FTD firewall.

thanks 

[Rob Ingram]

Ok sure if you want the IPS/malware functionality then I can see why you'd use the ASA.

ASA does NOT support DMVPN, routers only.

[adamgibs7]

Dear RJI,

As mentioned that PPOE connection from ASA will be through a RJ45 Ethernet interface, as if now the Branch router are having a RJ11 interface which are dialing through the line, so what i have to informed to the ISP when i moving to the Ethernet interface. do they will get some other device so that it can accept PPOE connection from my Ethernet interface,

Any hints please

thanks

[balaji.bandi]

Sure that solution works, as long as you do not have requirement remote to remote not required connection.

all connection go through the Hub