enabling line number in PIX 506

[chandrapradeep]

I have pix 506 having version 5.2(6)

i want to enable line number in the pix access-list as given below but i get error message:

pix(config)# access-list 104 line 1 permit ip any any

ERROR:<line> not a valid permission

Type help or '?' for a list of available commands.

pix(config)#

can somebody help me.

[stomasko]

From what I found it doesn't look like the line option is available for the PIX until version 6.3. You would need to upgrade to be abel to use that command.

Here is the 6.3 command reference link if you want to see it. http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_command_reference_chapter09186a00801727a3.html

Good luck

Steve