Hi there,
I've been trying to enable stateful firewall rules on this router and it won't accept the ip inspect command. Is there a licence or IOS version that I'm missing or feature that I need to activate?
router#sh ver
Cisco IOS Software, C860 Software (C860VAE-IPBASEK9-M), Version 15.1(4)M4, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2012 by Cisco Systems, Inc.
Compiled Wed 21-Mar-12 00:04 by prod_rel_team
ROM: System Bootstrap, Version 15.1(4r)M2, RELEASE SOFTWARE (fc1)
router uptime is 22 hours, 21 minutes
System returned to ROM by power-on
System image file is "flash:c860vae-ipbasek9-mz.151-4.M4.bin"
Last reload type: Normal Reload
This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html
If you require further assistance please contact us by sending email to
export@cisco.com.
Cisco 867VAE (BCM6368) processor (revision 0.3) with 234496K/26624K bytes of memory.
Processor board ID GMK1212016M
1 DSL controller
1 Ethernet interface
4 FastEthernet interfaces
1 Gigabit Ethernet interface
1 ATM interface
255K bytes of non-volatile configuration memory.
65536K bytes system flash allocated
router#conf t
Enter configuration commands, one per line. End with CNTL/Z.
router(config)#ip inspect ?
% Unrecognized command
