Hi,
I have 2 ASA5516 configured in failover mode.
On the primary active firewall, I am able to copy an image to it via FTP and also do other things.
On the Secondary standby firewall, I tried copying an image to its disk0, but I got the error; "Command authorization failed".
I noticed whenever I attempted any config command I got the same error, I can only perform show commands.
When i enter the; "show curpriv", I get this (below) which shows I have privilege level 15;
Current privilege level: 15
Current Mode/s : P_PRIV
Here's also the AAA config currently on the secondary standby device, which is the same as that on the primary active.
aaa authentication enable console ISE-TACACS LOCAL
aaa authentication http console ISE-TACACS LOCAL
aaa authentication ssh console ISE-TACACS LOCAL
aaa authorization command ISE-TACACS LOCAL
aaa accounting enable console ISE-TACACS
aaa accounting ssh console ISE-TACACS
aaa authentication login-history
Kindly let me know if you have experienced this issue and how it was resolved.
Thanks