02-26-2013 07:13 AM - edited 03-11-2019 06:05 PM
Hello NG
I would like to reset a ASA5505 to the Factory Reset. But i don`t know how. I don`t have the IP Adress. How can i get connect to the ASA?
Regards
Eric
02-26-2013 08:11 AM
Connect to the console port and issue command config factory-default.
02-26-2013 08:33 AM
Plus if you don't have the IP addrress you might very likely also not have the enable password.
So you'll have to recover the password by following this procedure and then wiping the configuration.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide