I have face problem regarding failover with two cisco 5510 ASA
the problem is that other host is FAILEAD.
Why this is failed, is it correct configuration of failover or not?
ACTIVE# sh failover
Failover On
Failover unit Primary
Failover LAN Interface: FAILOVER Management0/0 (up)
Unit Poll frequency 1 seconds, holdtime 3 seconds
Interface Poll frequency 3 seconds, holdtime 15 seconds
Interface Policy 1
Monitored Interfaces 3 of 110 maximum
Version: Ours 8.2(5), Mate 8.2(5)
Last Failover at: 09:43:30 PKT Aug 11 2013
This host: Primary - Active
Active time: 2562199 (sec)
slot 0: ASA5510 hw/sw rev (2.0/8.2(5)) status (Up Sys)
Interface DMZ (10.1.1.1): Normal (Waiting)
Interface Outside (125.209.70.90): Normal
Interface inside (192.168.11.249): Normal
slot 1: ASA-SSM-20 hw/sw rev (1.0/6.0(6)E4) status (Up/Up)
IPS, 6.0(6)E4, Up
Other host: Secondary - Failed
Active time: 0 (sec)
slot 0: ASA5510 hw/sw rev (2.0/8.2(5)) status (Up Sys)
Interface DMZ (10.1.1.2): Failed (Waiting)
Interface Outside (125.209.70.91): Normal
Interface inside (192.168.11.250): Normal
slot 1: ASA-SSM-20 hw/sw rev (1.0/6.0(6)E4) status (Up/Up)
IPS, 6.0(6)E4, Up
Stateful Failover Logical Update Statistics
Link : FAILOVER Management0/0 (up)
Stateful Obj xmit xerr rcv rerr
General 354676 0 328888 0
sys cmd 328961 0 328960 0
up time 0 0 0 0
RPC services 0 0 0 0
TCP conn 1768 0 0 0
UDP conn 609 0 0 0
ARP tbl 23394 0 0 0
Xlate_Timeout 0 0 0 0
IPv6 ND tbl 0 0 0 0
VPN IKE upd 8 0 0 0
VPN IPSEC upd 8 0 0 0
VPN CTCP upd 0 0 0 0
VPN SDI upd 0 0 0 0
VPN DHCP upd 0 0 0 0
SIP Session 0 0 0 0
Logical Update Queue Information
Cur Max Total
Recv Q: 0 17 328961
Xmit Q: 0 1487 2835111
ACTIVE#
Navaz
Navaz
