FDM Console from RA VPN

[TimReedSent]

Hi all,

Hope you are doing well!

I'm currently setting up a Cisco 1010 FirePower with FDM and have an issue with the RA VPN (fairly small network). Upon connecting to the VPN I would like to be able to access the FDM web console, however I cannot figure out how to set this up. I have management services using VLAN 10 so was looking to have it running there. I have set the Management Access section up to open the interface on VLAN10 IP and have set up an access policy from the VPN pool range to the IP address of the VLAN10 interface. When I connect to the VPN I can't access the FDM web console (but I can access other things on VLAN10).

Have I missed something here?

Thanks in advance!

[Rob Ingram]

@TimReedSent To manage the FTD using FDM over a VPN tunnel you will need to configure the command "management-access <interfacename>"  using Flexconfig.

[TimReedSent]

Hi Rob,

Thanks for your quick reply. I'm pretty new to Cisco, do you have a link to documentation/a guide on this?

Tim

[TimReedSent]

To add to the other reply, which interface should I be using for this when connected over the VPN? I have added the VLAN10 interface in the management access section of the web console but unable to connect to it on that port after connecting to the VPN.

Again, thanks for your help with this.