Firepower 1010 NAT configuration for dual isp
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-17-2020 12:21 PM
I have a Cisco FPWR 1010 and deployed FMC.
I looked through and read many manuals on the topic of dual isp configuration, but I have not seen an example of NAT configuration anywhere.
Can someone show how this should look in the FMC GUI for two isp?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-17-2020 12:58 PM
as long as you can understand the ASA code you can work it around. I personally have not see this document when it come to FTD. but as said if you have a solid understanding of ASA this will help you here
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-18-2020 07:25 AM
Hi,
If your problem is just NAT configuration, use this guide for regular NAT configuration, and do the same for your second ISP:
Afterwards, test it, and if there are issues, post it here.
Regards,
Cristian Matei.
