Firepower 2110 / ASA SNMPv3 Configuration

[zekebashi]

Hello, 

I am trying to configure snmpv3 on the ASA side of a Firepower 2110 but some of the commands are being rejected. I will not be using the FXOS at this time and only the ASA. I tried to type in the following command the same exact way as it is configured on a production ASA5510 but some of the parameters are not available. Here is the command that I am trying to use: 

snmp-server user wxyz v3 encrypted auth sha xxxxxxxxxxxxxxx priv aes yyyyyyyyyyyyyyy

In the new ASA/FirePowere 2110, when I try to type, I receive no hash (MD5 or SHA)or encryption options (AES)

snmp-server user wxyz v3 auth ?

     configure mode commands/options: 

      <cr>

snamp-server user wxyz v3 priv ?

     configure mode commands/options 

     <cr>

This doc is related to configuring snmpv3 on the FXOS not the ASA: 

https://www.cisco.com/c/en/us/td/docs/security/firepower/620/configuration/guide/fpmc-config-guide-v62/platform_settings_for_firepower_threat_defense.pdf

Thanks in advance, ~zK 

[zekebashi]

I was able to fix this issue. It turned out that since 3DES/AES license wasn't enabled. Once I enabled and activated the license, I was to executed the snmp v3 command successfully. 

I hope this helps anyone who might run into a similar issue. 

~zK