Firepower 2130 single route modifying all the static routes

[naveen98]

Dear Community, 

I have completed a single static route  addition on our Firepower production Firewall via FMC and the deployment review is showing that it is modifying all the static routes (adding all static routes). Kindly support on this because i have some urgent policy configurations that needs to be deployed.  

Cisco Adaptive Security Appliance Software Version 9.18(3)39
SSP Operating System Version 2.12(0.499)

[Marvin Rhoads]

That's not normal. I just tested in my lab FMC and confirmed that adding one static route only shows that one single route in the deployment preview. Try removing that one route you added and see if the deployment preview still shows the others as being modified. If it persists, you might want to open a TAC case.

[naveen98]

Dear Marvin,

I have removed the new route but still the deployment preview showing the route changes.

[Marvin Rhoads]

You might want to compare the changes showing as pending vs the "show running-config route" on the device.

[nspasov]

It is hard to provide suggestions with the information that has been shared. Can you provide additional information? E.g., 

1. Change log
2. FTD version
3. Hardware type
4. etc. 

Thank you for rating helpful posts!

[nspasov]

Thank you for rating helpful posts!

[naveen98]

1. Change log from audit log

2. FTD version 

Model : Cisco Firepower 2130 Threat Defense (77) Version 7.2.4 (Build 165)

3. Hardware type 

2130 in HA 

Hardware: FPR-2130, 13702 MB RAM, CPU MIPS 1200 MHz, 1 CPU (12 cores)