Firepower Access Policy Comparison - not existing????
When policies has changed (multiple times) and you need to deploy a Policy.
How can you verify the Difference / how can you compare the
- Policy to deploy - with the - Policy deployed?
before you kick of the task?
Accordingly to the Firepower Management Center 6.2.3 here is no options to compare Access Policies:
To review policy changes for compliance with your organization's standards or to optimize system performance, you can examine the differences between two policies or between a saved policy and the running configuration.
Are we the onlyone on the whole world needing this? I mean, CSM Cisco Security Manager has been able to do this since the last 10 years.....
You would like to use the ASA Firewall Umbrella Connector to enforce DNS policy with Umbrella. However you would also like to exclude certain IP addresses or subnets from using this policy. I recently had the need to do this, had a bit of tro...
Hi Everyonem Just wondering if anyone knows why I am getting an error that says "Cryptographic algorithms required by the secure gateway do not match those supported by AnyConnect. Please contact your network administrator.". See attached...
The Cisco 2020 CISO Benchmark Report provides valuable takeaways and data on the most pressing topics: the impact of vendor consolidation, cybersecurity fatigue, outsourcing, top causes of downtime, the most impactful threats, and more. The repo...
Hi, Has anyone run into the "Channel down" issue when updating the identity certificate on the Stealthwatch SMCv and SFCv. I'm doing a POC for a client and every time I go an update the identity cert the SMC says "it could save the configuration" and...
On July 16 2020, the U.K. National Cyber Security Centre and Canada’s Communication Security Establishment, in cooperation with the U.S. National Security Agency and Cybersecurity and Infrastructure Security agency, issued an advisory [...