Firesight 4000 - high availability on software version 6.0

[lucia.anta]

Hello,

I have two Firepower Management Center FS4000 with software version 6.0.1.2. The documentation explains that HA pair is not supported in this version. How can I do to mantain a primary defense center and a secondary defense center?

[Oliver Kaiser]

Upgrade to version 6.1. High-Availability was re-introduced in 6.1 which supports configuration syncronization. Automatic failover is currently not supported so a manual promotion must be triggered which should change in a later release.

If cold-standby is ok with you, you could backup your FMC configuration regularly and restore it to your standby FMC but I think upgrading would be the better idea...