FireSIGHT Dashboard

[chee-meng_hong]

Hi,

I have installed FireSIGHT virtual appliance and connect to 2 ASA-X devices.

In the default FireSIGHT dashboard, I would see the summary of 1st device.

How can I view the summary of the 2nd device?

Thank you.

CM

[Marvin Rhoads]

Can you share a screen shot of what you're asking about?

My FirePOWER Management Center (version 6.1.0.1) shows all of my devices in the Summary Dashboard.

[chee-meng_hong]

My version is 5.4.1.7 build 23.

I followed these steps and get error (see attach).

***

Step 1 From the drop-down list under your user name, select User Preferences.

The Change Password page appears.

Step 2 Click Dashboard Settings.

The Dashboard Settings page appears.

Step 3 Select the dashboard you want to use as your default from the drop-down list.

If you select None, when you select Overview > Dashboards, the Dashboard List page appears. You can then select a dashboard to view.

Step 4 Click Save.

Your default dashboard preference is saved.

***

[Marvin Rhoads]

Are you signed in as admin or with an account that has admin privileges?

I went through the same steps on my system and it worked fine. I don't see any documented bugs that would cause this behavior.

However, you might want to consider upgrading to the current FMC. Version 5.4 is getting quite old in terms of the changes that were done in 6.0 and 6.1.

[chee-meng_hong]

We signed in as admin.

We used one management interface to manage multiple devices.

Is this the problem?  

[Marvin Rhoads]

Admin login should be fine.

I'd open a TAC case and/or upgrade to a current version.