03-04-2007 05:35 AM - edited 03-12-2019 05:48 PM
Dear all,
If I have 2 UR licenses for primary Firewall, can I make one of them as Failover.
TIA
03-04-2007 11:34 AM
yes. you just need to designate one of them as standby in the config if you are doing lan based failover
HTH
03-04-2007 09:58 PM
Thanks Justin,
I will make the other as standby and test them if it works fine. Is there any special configs for that or same as usual.
Regards
Faiz
03-05-2007 05:31 AM
The configs should be the same as if the second pix was failover only. The following link from cisco will aid you in the config of a lan. The biggest thing to keep in mind is that the two pix must be identical
03-05-2007 06:04 AM
Hi Faiz,
if you have two UR license firewall, you can
run them in Active/Active if you like.
If you decide to make it Active/Standby, get
a FO firewall, it is much cheaper. But
Active/Standby configuration will work with
both UR firewalls but you're wasting your money.
David
CCIE Security
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide