Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello I am having trouble setting up a symbol netvision phone with my cisco ap 350 that is running 12.01T. Basically, when the phone powers up it finds the SSID for my network (if i enable the broadcast SSID). It does not seem to get an IP Address...
Has anyone had those annoying popup advertisements come up on inside servers? I believe they are run through MS Messager Service. I would love to block these on my PIX. I cannot figure out which port(s) this service is using. Any help would be gr...
you need to set the heap size for the version you are running. if you click the help button on the message box that pops up it explains exactly how to modify this value. i don't recall exactly the string to type..please reply if you still have issu...
just to add to this...files in flash do not transfer over. however the asa determines which asdm version to use via the "asdm image disk0:image.bin" command. this command gets replicated. so if both ASA have the appropriate asdm image file (which ...
hiyou need to have an acl that allows this traffic. A. HSRP hello packets are sent to multicast address 224.0.0.2 using UDP port 1985. Whenever an ACL is applied to an HSRP interface, ensure that packets destined to 224.0.0.2 on UDP port 1985 are pe...
you need to tell the pix which hosts/networks are allowed to telnet to the pix. for example if you want just your ip address to telnet, and your ip is 192.168.1.100 you issue "telnet 192.168.1.100 255.255.255.255 inside" If you are running version ...
if you want to go to an extreme you can issue a "write erase" to wipe out the config complete and then you should be able to cut and paste the backup that you have. if the config is lengthy i would recommend only pasting 20 or so lines at a time as...
