- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-13-2023 02:37 AM
Hi,
I have task of deploying 25-30 FPR1010 managed from FMC.
Is there an easy way to clone/copy interface/subinterface setup from a standard device or do I really need to type in all the interface config via the GUI. The IP is of cause different but names, interface numbers etc. should be the same on all devices.
TIA
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-13-2023 06:09 AM
The alternative is to use the API. However, if it's not something you do often, the work to set it up may exceed the work to just configure each via the GUI.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-13-2023 06:09 AM
The alternative is to use the API. However, if it's not something you do often, the work to set it up may exceed the work to just configure each via the GUI.
