FPR-1010 sub inerfaces and DHCP relay

[Martin]

Hi,

I need to create sub ports on the inside interface for VLANs 10,20,30,40 and 100 and each subport needs to be pointed to my DHCP server is this possible please.

I could get away with creatin just access ports for each VLAN but would still need to point them to me DHCP server.

Is this possible, if so any guides for this?

TIA

[MHM Cisco World]

Switch 

MHM

[ccieexpert]

Here is a good guide to how to use the API:

https://developer.cisco.com/learning/modules/fdm-api/FDM_RESTAPI_102/introduction/

i can help you

[Martin]

if i upgrade to 7.2.x then that adds the DHCP relay to the GUI

[Rob Ingram]

@Martin no, unfortunately that is for FMC not if using FDM, as per the 7.2 release notes under the Management Server section https://www.cisco.com/c/en/us/td/docs/security/secure-firewall/release-notes/threat-defense/720/threat-defense-release-notes-72.html

And the FDM 7.4 guide still states you configure DHCP relay using API. https://www.cisco.com/c/en/us/td/docs/security/firepower/740/fdm/fptd-fdm-config-guide-740/fptd-fdm-advanced.html

If you don't require NGFW functionality on the FDM, you could just reimage the device to ASA code.

[Martin]

Is there any guide on doing it with API?

[Martin]

I have trioed to install FMC to do it but please see https://community.cisco.com/t5/network-security/error-when-installing-vfmc-onto-vmware/m-p/5147635#M1114454