FPR 1120 is not updated via FDM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-02-2025 12:38 AM
Firmware 7.0.1-84 is installed. I try to install any firmware. The system reboots after a minute and returns back to 7.0.1-84. Entry in status.log :
ui: Upgrade in progress: ( 5% done.36 mins to reboot). Checking device readiness... (000_start/106_check_HA_state.pl)
ui: Upgrade in progress: ( 5% done.36 mins to reboot). Checking device readiness... (000_start/107_version_check.sh)
ui: Upgrade in progress: ( 5% done.36 mins to reboot). Checking device readiness... (000_start/108_clean_user_stale_entries.pl)
ui: Upgrade in progress: ( 5% done.36 mins to reboot). Checking device readiness... (000_start/110_DB_integrity_check.sh)
ui: Upgrade in progress: ( 5% done.36 mins to reboot). Checking device readiness... (000_start/113_EO_integrity_check.pl)
ui: Upgrade in progress: ( 5% done.36 mins to reboot). Checking device readiness... (000_start/125_remove_duplicate_rules.pl)
ui: Upgrade in progress: ( 5% done.36 mins to reboot). Checking device readiness... (000_start/200_clean_csp_files.sh)
ui: Upgrade in progress: ( 8% done.35 mins to reboot). Checking device readiness... (000_start/250_check_system_files.sh)
ui: Upgrade in progress: ( 8% done.35 mins to reboot). Checking device readiness... (000_start/320_remove_backups.sh)
ui:__[] Fatal error: Upgrade Failed. The upgrade was interrupted by a system restart.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-02-2025 12:44 AM - edited 05-02-2025 03:28 AM
this is an error when updating to 7.0.2-88
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-02-2025 08:07 AM
I would open a TAC case
