Hi to all,
a little bit confused about configuring the equivalent of command "ip helper address" in FMC.
My topology is like this:
<---Inside-dhcp-clients_vlan100----> FTD <--outside interface_vlan_27--> 6500 <-- SVI where the DHCP SERVER lives -->
What i want is the DHCP clients that are in different VLANs in FTD to be able to get their IP address from the remote DHCP server.
The FTD is also a DHCP server for an additional VLAN.
For example the dhcp clients reside in vlan 100 in FTD. The DHCP server (192.168.65.7) is reachable via OSPF from the FTD outside interface which is vlan 27.
What i tried to configure is in the png attached:
The problem is that i can not save any change as i get the error message you see in the png.
Any ideas?
Thanks,
Ditter.
