FTD - Inline Set

[ibrahim.imad]

Dears,

I have an FTD that have 3 Interfaces (Inside, Outside and DMZ). This FTD should be implemented in transparent mode and Only-IPS should be applicable. As per cisco documents, in transparent mode we must create Inline Set between interfaces to be able to use it in transparent mode with IPS-Only.

But in the Inline Set, I can add only 2 interfaces, and I can only create 1 Inline Set.

So What should we do with the third interface?

Thank You.

[Sheraz.Salim]

If you create a Bridge-Group and call all the interface than you can bring all in your interfaces in transport mode.

here is the link https://www.ciscolive.com/c/dam/r/ciscolive/us/docs/2019/pdf/BRKSEC-2020.pdf page 172