Hi I have a FTDv-2130 version 6.3.0 managed by a FMC with version 6.5.0.2; and i can't find etherchannel in main page of the device when i want to add an etherchannel interface. see below the picture. Thanks
Have a 1010 running 6.6.4 with 10 rules, 1 of which allows the internal DNS server outbound dns over udp and tcp for server from inside to outside. The server fails dns resolution and packet tracer shows the traffic dropped because it hits the defaul...
Hi Everyone, I have FTD-1100 and registered with FMC1500, and also have FMC1600 with FTD-4125 registered. I want to migrate the FTD-1100 from FMC1500 to our new FMC1600. Can someone please help me with it, because I don't want to reconfigure the FTD-...
I am using the FMCv for my home network setup and was wondering if there are any plans to phase out the FMCv in the next few years? I'm on a demo now but planning to purchase it but dont want to waste money on something that is going to be phased ou...
I want to create a port forwarding rule on an Asa 5506 running ASDM 7.13. I have no problem making this work when the outside port is same as the internal port. So let's say, I need to allow ip 1.1.1.1 to connect to an FTP server running inside my ne...
Hi Dudesi'm trying to deploy new network&group objects on set of ASAs under CSM 4.19 management.I've submitted needed objects in CSM (conducted it via approval process @least so they dont show uncommited icon anymore).I supposed them to populate need...
Dear Team,We have received on requirement as below:We have one Any connect VPN which we want to use to communicate with our one IPSEC VPN.How can we achieve this? Please find attached topology.Any connect VPN subnet 192.168.40.0/24 want communicate w...
Hello, We had deployed the ASAV with azure with the version Software Version 9.16(1) we are able to access the device via serial console and can enable it but now we can't go to enable mode with the the same credentials so and not sure to remove the ...
Hello community, our customer has upgraded the FMC and the FTDs from rel. 6.6.1 to 6.6.4 and since that time he gets a red bubbleon a HA cluster of two FTD5516-X (see attached device overview). Other HA clusters of two FTD5516-X with same number of A...
About a week ago, our ASA 5545 started to scan random ports on our management server. The AV detects the port scan, and throws up a temporary block on traffic, which means the device randomly goes down for 10-15 minutes throughout the day and night. ...
Hello community, I am trying to setup a site to site IPSec VPN tunnel using two Cisco RV340 routers. I have followed the instructions in this link from Cisco: Configure a Site-to-Site Virtual Private Network (VPN) Connection on an RV340 or RV345 Rout...
Hi All,Wondering if anyone is using ISE 3.0 REST ID with Azure AD ? (https://www.cisco.com/c/en/us/support/docs/security/identity-services-engine/216182-configure-ise-3-0-rest-id-with-azure-act.html) If yes, once you've added Azure AD as an External...
Hey guys, I hope you are doing well. I have problem understanding how redundancy works in an H.A. (Active/Standby) FTD when it comes to IPSec tunnels. To clarify more:- Our office is connected to 2 ISPs. We created two IPSec tunnels, each one of them...
