FTD management route not seen

[h.dam]

Hello,

I have a FTD 2130 with 6.7 firmware.

On the FDM GUI, management interface is configured with a gateway address using mgmt interface.

But when I connected this FTD via ssh, then by using > show route, I got nothing  about  the mgmt network.

As a result, I cannot ping the GW.

I have also tried to add a static route => result was the same error, cannot ping the GW.

What I need is to separate the mgmt traffic from Data traffic.

[Rob Ingram · Accepted solution]

Hi @h.dam 

"show route" would only show the routing table of the data interfaces, not the management interface. Use the command "show network" to determine the default route for the management interface.

If you want to ping from the management interface use "ping system x.x.x.x" if you want to ping from a data interface you would use "ping x.x.x.x".

HTH

[h.dam]

Thank you very much for your quick reply.