h.dam
Beginner
Beginner
Member since ‎12-14-2001
‎06-13-2022

User Statistics

  • 152 Posts
  • 4 Solutions
  • 82 Helpful votes Given
  • 85 Helpful votes Received
Recent Badges
 30 Helpful Vote
10 Helpful Vote
1 Helpful Vote
1 Accepted Solution
50 Replies
20 Replies
10 Replies
5 Replies

User Activity

Hello all, I have a pair of FTD 2130 with A/P. They both have different mgmt IP address.Last week I got peer failed error so I tried to connect them via console port. I realized that I cannot connect to Standby device via console port while I can use...
Hello,I'd like to know if it is possible to create a read only user account to access FTD 2130 using FDM (I don't use FMC)I have tried to create a user by CLI: config user add xxx basicThis user account can only access the device via SSH but came out...
Hello all,We have a FTD A/P pair registered after purchase. They are working well until last month. They have lost the licenses without reason and became unregistered.This is the first time I met after more than ten years pratices on Cisco devices.I'...
Hello,I have tested the FPR 2100 HA pair switching time in lab, it took 10 sec.For our production environment, it is too long.I remember that ASA 55xx A/S switching is immediately. Do you have the same time?Maybe there are some specific settings for ...
Hello,I configured a pair of FTD 2130 as active/passive but they didn't synchronise and gave "peer failed" error.The "show failover state" showed there are monitored interfaces "no link" error.These interfaces on FTD are configured using Ethernet cha...
Community Statistics
Member Since ‎12-14-2001 08:26 AM
Date Last Visited ‎06-13-2022 01:27 AM
Posts 152
Total Helpful Votes Received 85