- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-18-2019 12:44 PM - edited 02-21-2020 09:03 AM
I am testing out a FTD conversion from ASA on a 5516-X. I have FTD version 6.3.0 loaded and working. I want to factory reset FTD and start from scratch with my config. is there an easy way to do this in the FTD software? i don't want to re-image it if I don't have to
Solved! Go to Solution.
- Labels:
-
NGFW Firewalls
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-21-2019 09:46 PM
Unfortunately, there's no other option to do this without using reimage procedure.
Thanks
Francesco
PS: Please don't forget to rate and select as validated answer if this answered your question
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-21-2019 09:46 PM
Unfortunately, there's no other option to do this without using reimage procedure.
Thanks
Francesco
PS: Please don't forget to rate and select as validated answer if this answered your question
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-22-2019 06:52 AM
Change it from local management to remote management (or vice versa) from the cli. That should cover everything but the bootstrapping bits.
