06-04-2021 05:37 AM - edited 06-04-2021 05:38 AM
Hello
I have FTD 6.4.0.8 with FMC, hardware ASA 5525-X.
And i have a lot of syslog messages: "[ Scanning] drop rate-1 exceeded. Current burst rate is 5 per second, max configured rate is 10; Current average rate is 16 per second, max configured rate is 5"
According to https://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/113685-asa-threat-detection.html i want to change average rate and burst rate of Basic Threat Detection.
But there are no CLI command like:
threat-detection rate acl-drop rate-interval 1200 average-rate 250 burst-rate 550
Are there another ways to do this?
Thank you!
Solved! Go to Solution.
06-04-2021 02:36 PM
You can configure these options via flex-config:
Regards,
Chakshu
Do rate helpful posts!
06-04-2021 02:36 PM
You can configure these options via flex-config:
Regards,
Chakshu
Do rate helpful posts!
08-13-2023 07:35 AM
Can someone be so kind to walk me through the steps on configuring Threat-detection on an FTD box please. I've tried to use FelxConfig for other things and I just don't understand how to enter the commands I want to enter.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide