FTD2130 failover via SNMP

[domac385]

Hi everyone,

I am trying to configure alarm for failover via SNMP, but cannot find the appropiate OID with which I can do this.

I have similar configured for ASA-5525 with OID 1.3.6.1.4.1.9.9.147.1.2.1.1.1 and is working.

But on the FTD I don't find this OID or cannot say which OID should I use for it?

We have two FTD2130 appliances configured in HA mode. I want to get notified when active/standby roles are switched. As mentioned above I have this configured on ASA-5525, and I am unable to configure it on this platform.

Any help appreciated

[Marvin Rhoads]

Are you querying the FTD with SNMP via the diagnostic interface? Only by using that will you get the SNMP OIDs roughly equivalent to the ASA from the LINA susbsystem. Otherwise you will get the FXOS SNMP OIDs only (via management or SNMP-allowed data interfaces).