Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
745
Views
0
Helpful
4
Replies

FWSM chassis query

thetone69
Level 1
Level 1

‎06-15-2009 10:55 PM - edited ‎03-11-2019 08:43 AM

Hi folks,

is there a way of issuing a command to tell you what switch you are on when you are logged into the FWSM ie if switch name is SW1 and the FWSM is FWSM1. How would I know that I'm on SW1?

Labels:
0 Helpful
4 Replies 4

j.docio
Level 1
Level 1

‎06-16-2009 12:39 AM

I use the "show failover"... it will show you if you are on the "Primary" fwsm.

Regards.

0 Helpful

francisco_1
Level 7
Level 7
In response to j.docio

‎06-16-2009 12:44 AM

i dont think you can!. might be wrong.

0 Helpful

Jon Marshall
Hall of Fame
Hall of Fame

‎06-16-2009 12:49 AM

Without wishing to state the obvious we used to just name the FWSM so you could match it up with the switch ie.

switch = DC-BBP-F00-DS1

FWSM = DC-BBP-F00-DS1-FWSM1

etc..

Jon

0 Helpful

francisco_1
Level 7
Level 7
In response to Jon Marshall

‎06-16-2009 12:52 AM

extactly what we do.

in jon's example, we use

SW-DC-BBP-F00-DS1

FW-DC-BBP-F00-DS1

FW for the FWSM

SW for the SW hosting the FWSM..

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card