FWSM failover: Context State after failover is FAILED,why ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-06-2009 03:50 AM - edited 03-11-2019 09:23 AM
Hi every one,we have two FWSM in our 6509 switches,fwsm's are in multiple context mode and are configured for active/active.we have two context= admin and public.here is detail:
FWSM-1=admin(active) public(standby)
FWSM-2=admin(standby) public(active)
so recently for some reason we had failover for FWSM-1 but now every thing is normal except that in fwsm-1 admin is active that shuld be BUT context public which should be in standby-ready is in FAILED state,why?is this for last failover? and now if fwsm-2 fails what would happen?fwsm-1 wont take active rule? consider this that in fwsm-1 context admin monitored interfaces are normal but in fwsm-1 context public all monitored interfaces are in failed state just as context state?
- Labels:
-
NGFW Firewalls
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-07-2009 02:26 AM
please,i need your advise!
