We are facing one issue regarding FWSM module in Cisco 6509 switch. We have two Cisco 6509 switches and configured in VSS mode one FWSM modules are placed in each switch. But not able to take a session of FWSM module from switch command line.
We are able to take session only if we boot the FWSM module in maintenance mode ( CF:1) . If we take session of FWSM module through maintenance mode then we are able to configure IP address to it and then it can be accessed through outside network also but did not able to take session of FWSM module in application mode ( CF:4 or CF:5)
Pls help on the issue.
