02-12-2007 11:56 AM - edited 03-11-2019 02:32 AM
Can the session slot ......command be used to navigate between different FWSMs in 6513?
02-13-2007 02:13 AM
Hi ..
definetely .. you can connect to any module that allows interactive access using the session command .. do a show module and identify the slot your need to connect. If you need to connect to more than one module at the same time using the session command then you could have two separate remote sessions to the supervisor and from there open a session to every FWSM respectively
I hope it helps .. please rate if it does !!
02-13-2007 09:27 AM
But the sh module is not working on FWSM...
02-13-2007 10:20 AM
Aksher,
You could either use session slot x proc 1 or if you pull out the blade there is a hidden console on the blade. You could connect a serial cable to connect and get on the physical console of blade.
02-13-2007 10:30 AM
Hi
The show module command will not work on the FWSM. You need to exit back out of the FWSM to the switch then session to another of your FWSM's.
You cannot session from one FWSM direct to another FWSM as far as i know.
HTH
Jon
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide