getting start with IPS

[ronshuster]

We have the IPS module on the ASA, we connected each module to the internal core switch and using the ASDM attempted to give it an IP address and begin the configuration.  However when defining the IP address (along with the username\pw) I get an error msg saying:

"Error connecting to Sensor. Error loading sensor"

Any idea?

Also, do you have any good tips to configure this IPS (SSM10)?

[Federico Coto Fajardo]

Hi,

Can you enter to the IPS module with the session command from the ASA's CLI?

Please go through this document and let me know if you have any problems.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a008080f2d1.shtml

Federico.