Hi there, I am currently using Solarwinds to monitor a network and it provides visitbility to interfaces being up\down, high cpu threash-holds, high throughput, etc. However I'm looking for more granular info such : 1) CRC errors on the interface 2) ...

tyring to enable : crypto ikev1 enable outside  and I get :ERROR: IkeReceiverInit, unable to bind to portI don't have udp500\4500 used anywhere.how can this be resolved?

I have an ASA and I need to run eigrp but I am seeing that it only supports OSPF.I thought once routing is supported eigrp shoudl be there by default, is this IOS driven?How do I enable eigrp??Here's a sh ver:System image file is "disk0:/asa708-k8.bi...

we have a cisco 881 router with a dynamic vpn connection to an asa5520 with average of 70ms with very little fluctuation and minimal packet loss.At the 881 site we have a dsl line with 15MG download speed and 2MG upload and the circuit is nowhere nea...

We have dynamic vpns from our head office (ASA5510) to a number of ASA5505's and PIX's at the remote sites, which works fine.Recently we've introduced another vlan at the head office and need this vlan to access the remote sites, after adding the nec...