GUEST NETWORK (EASY QUESTION)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-05-2008 07:24 AM - edited 03-11-2019 07:21 AM
Hey Guys!
Here is my small situation.
Our guest network is only able to get to the internet, so if anyone comes in our building, they will only have access to networks that are less secure.
I want this network to have access to our WEBVPN, which is 216.12.5.2 (its an outside IP address), however when i try to go to this address, it says "page cannot be displayed"..
I believe its an access list on my firewall (maybe), but i have tried a few and still cannot hit this site... ANY IDEAS?
- Labels:
-
NGFW Firewalls

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-05-2008 07:52 AM
what platform are you using, it is capable of same security or intra security traffic? you also need to think about using the alias command.
HTH>
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-05-2008 07:55 AM
ASA 8.0..im really not familiar with the Alias command?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-05-2008 08:08 AM
not sure if it's still available in 8.0 - easy way to check at the cli type alias ?
I'm sure the help will enlighten on the rest of the syntax.
As your version does support inter & intra communication:-
http://www.cisco.com/en/US/products/ps6120/products_tech_note09186a0080734db7.shtml
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-05-2008 08:45 AM
See attached...
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-05-2008 08:47 AM
Errrrm review the access-list "acl-drop" this is stopping things from working.
HTH>
