I just upgraded an ASA-5510 from 7.0 to 8.4.4-1 and theres a lot of stuff in it I don't recognize that I never added, mostly because of new network objects, nat commands, and other migration stuff. Its been awhile since I've configured the ASA and I think I'd like to start from scratch and clean it up a bit because theres so many lines for so little that I really need. I just think its sort of a mess right now so I was hoping someone could help me with the commands to do the following tasks.
I have a 5510 assigned an IP address on the outside interface with 3 inside interfaces and below are the only requirements I need.
Network-A (192.168.1.0/24)
- incoming ssh port 2202 goes to node 192.168.1.2
- incoming ssh port 2203 goes to node 192.168.1.3
- handle incoming https (443) requests
- handle incoming www (80) requests
- cannot see Network-B or Network-C
Network-B (10.0.0.0/16)
- ssh to nodes on Network-A
- incoming ssh port 22 goes to node 10.0.0.20
Network-C (192.168.2.0/24)
- ssh to nodes on Network-A
- incoming ssh port 2210 goes to node 192.168.2.2
ASA-5510
- sends logging to syslog node 192.168.1.3 on Network-A
- there are DNS and NTP servers located outside
Any help much appreciated.