cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1414
Views
0
Helpful
1
Replies

How to configure DC/ASA for traffic spanning.

endpoint
Level 1
Level 1

Hello,

 i have a demo SF DC and ASA (sfr) and would like to span live traffic to the DC so i can present it to the upper management and hopefully have it in budget for next year.

My DC is configured, i have ASA added, have licences but not sure how to configure DC/SF in monitor mode. The purpose is to span all production traffic and not to block anything. Would you guys be able to provide some guidances/docs? Thanks

1 Reply 1

endpoint
Level 1
Level 1

Need to have ASA in transparent mode, one interface (g0/0) connected to spanned port; managemetn interface connected to DC, add sfr sensor to DC, setup access policy to trust all traffic and assign policy to ASA.

this should do the trick.

 

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card