Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hi,I have cisco ASA 5510 8.4 and I want to connect it with TMG (ForeFront Management Getway) as the following  Internet ------ASA-------TMG-------usersWhat is the configurations required to allow traffic outgoing TMG to go the internet through ASA ??...

tareken87 by Level 1
  • 1789 Views
  • 0 replies
  • 0 Helpful votes

Hi, The scenario -Clients on the LAN use a public DNS server for their DNS; the local clients must resolve the local email servers IP address as the public IP address, which is performed through NAT. The clients can access email (OWA) when they brows...

Resolved! 5525-X Setup

I have to setup a new 5525-X firewall with IPS (softwaree module) in transparent mode, appreciate if someone clarifies my doubts.a) On this model what are the minimum required commands at the interface level after setting the firewall mode in transpa...

avilt by Level 3
  • 2550 Views
  • 12 replies
  • 0 Helpful votes

Hi,I am wondering if it is possible to run a dual ASA dual (active) ISP scenario. Here is what I have to work with-ASA 5510 Base-ASA 5505 Sec+-3560 L3 switch-Two separate ISPsWhat I would like to do is setup one ISP to run only voice traffic while th...

Hi, can  some  one  guide  me to  configure  Hide  NAT on the Cisco ASA 5510 Firewall.  i am  using  the  ASA in my  network.The  users  at  inside  interface   traffic   need to  go  to  the  DMZ  interface  and  access the remote  three   servers  ...

Resolved! NAT , ASA 9.1

Hello,                                        Outside                                      ip: 10.7.128.172-DMZ                                       |Ironport                   ---------   ASA10.2.129.95                            |                 ...

apapakons by Level 1
  • 6245 Views
  • 23 replies
  • 0 Helpful votes

Is there a way to internally route between contexts on an ASA firewall. For example: say I have two contexts on my ASA (Context A and Context B). Is there a way to route from Context A to Context B without the use of another device?

Dear, I have problem in my ASA 5515-X , when i make Remote access VPN to servers in inside zone the internet connection disconnected in the servers, or when i have internet in servers, the remote access cant reach servers. the configuration for serve...